0
AQUASPA START-UP KIT

AQUASPA START-UP KIT

$408.25 NZD
AQUASPA TEST STRIPS

AQUASPA TEST STRIPS

$61.70 NZD
AQUASPA SPA SHOCK

AQUASPA SPA SHOCK

$48.95 NZD
AQUASPA INSTANT FILTER KLENZ

AQUASPA INSTANT FILTER KLENZ

$45.02 NZD
AQUASPA ANTI-FOAM

AQUASPA ANTI-FOAM

$37.24 NZD
AQUASPA CHLORINE REMOVER

AQUASPA CHLORINE REMOVER

$36.12 NZD
AQUASPA SPA SANITISER

AQUASPA SPA SANITISER

$35.15 NZD
AQUASPA SPA KLEER

AQUASPA SPA KLEER

$32.37 NZD
AQUASPA INVIGORATE

AQUASPA INVIGORATE

$22.67 NZD
AQUASPA pH REDUCER

AQUASPA pH REDUCER

$22.13 NZD
AQUASPA SPA PAD

AQUASPA SPA PAD

$19.33 NZD
AQUASPA ALKALINITY ENHANCER

AQUASPA ALKALINITY ENHANCER

$18.16 NZD
AQUASPA CALCIUM ENHANCER

AQUASPA CALCIUM ENHANCER

$18.16 NZD

Troubleshooting
& Solutions

If you have any problems with your spa, please check the suggested solutions as these issues may be caused by improper adjustment or application of chemicals.

Cloudy Water

Cloudy water can be caused by one of 4 issues

1. INCORRECT WATER BALANCE

  • Check and adjust pH to between 7.4 – 7.6
  • Check and adjust Alkalinity to between 125 – 150ppm

2. INCORRECT DOSING OF AQUASPA™ SPA SANITISER AND/OR AQUASPA™ SPA KLEER

Either too much or too little can cause cloudy water.

  • Test the sanitiser level – this should be 15-20ppm
  • If spa has been overdosed
    • Remove 1/3rd of the water
    • Dilute with fresh water
    • Retest

3. BLOCKED FILTER CARTRIDGES

4. BUILD UP OF BODY FATS IN PIPE WORK


Foaming

  • Add one cap of AQUASPA™ ANTI FOAM to stop foaming
    • However, this will only mask the problem and not eliminate it

Foaming is usually caused by either high levels of sanitiser, incorrect Water Balance or an excess build-up of body fats in the filter or pipe work

To correct the problems

  • High levels of sanitiser
    • Check sanitiser level and correct the dose if necessary

Offensive Odour

A strong chemical or offensive odour is usually caused either by
  1. Too low a pH
  2. Overdosing with AQUASPA™ SPA SANITISER
  3. The presence of body fats
To remedy
  • Check and adjust pH
  • Dilute spa with fresh water if necessary
  • Body fats can be treated by a dose of AQUASPA™ SPA SHOCK and adding fresh water if necessary

Brown Scum

A light brown scum around the waterline may occur.

This can be caused by

  • The quality of your source water and any possible impurities
  • if you have the jets and /or bubbles running when adding AQUASPA™ SPA SANITISER

If you encounter this


© 2025 Aqua Spa Products Ltd. All rights reserved. Website design by fuel.

0 ITEM
×